Differences

This shows you the differences between two versions of the page.

--- exchange_server_2003_installation [2017/11/06 02:41] – wikiadmin
+++ wiki:exchange_server_2003_installation [2017/11/06 04:24] (current) – external edit 127.0.0.1
@@ Line 23: / Line 23: @@
 Install and enable the Windows services required for Exchange
-Run the DCDiag tool.
+Run the [[wiki:dcdiag|DCDiag]] tool.
-Run the NetDiag tool.
+Run the [[wiki:netdiag|NetDiag]] tool.
-Run ForestPrep
+Run [[wiki:ForestPrep|ForestPrep]]
-Run DomainPrep
+Run [[wiki:DomainPrep|DomainPrep]]
-Run Exchange Setup
+Run [[wiki:Exchange Setup|Exchange Setup]]
 For more information about the DCDiag and NetDiag tools, refer to the Exchange Server Deployment Tools. It is recommended that you run the DCDiag and NetDiag tools on every server on which you plan to install Exchange Server 2003.
@@ Line 37: / Line 37: @@
 When you use Exchange Server Deployment Tools, you can run specific tools and utilities to verify that your organization is ready for the Exchange Server 2003 installation. If you do not want to run Exchange Server Deployment Tools, read the remaining sections in this topic for information about manually installing Exchange Server 2003.
-Configuring the Windows Time Service
+[[wiki:configuring_the_windows_time_service|Configuring the Windows Time Service]]
-More Tasks Before Applying Exchange 2003 Service Packs
+[[wiki:More Tasks Before Applying Exchange 2003 Service Packs|More Tasks Before Applying Exchange 2003 Service Packs]]
-Apply Exchange Server 2003 SP2
+[[wiki:apply_exchange_server_2003_sp2|Apply Exchange Server 2003 SP2]]
-__Per Exchange server 2003 SP2 Release Notes: __Apply Hot fix from Knowlege Base Article 905214 before you install Sender-ID in your environment (__or instead apply Windows Server 2003 SP2__ which includes the hotfix). These Release Notes State: __Required Sender-ID Hotfix__ Make sure that you install the following hotfix before you install Sender-ID in your environment.
+**Per Exchange server 2003 SP2 Release Notes:** Apply Hot fix from Knowlege Base Article 905214 before you install Sender-ID in your environment (**or instead apply Windows Server 2003 SP2** which includes the hotfix). These Release Notes State: **Required Sender-ID Hotfix** Make sure that you install the following hotfix before you install Sender-ID in your environment.
 Before you enable Sender ID on Exchange 2003 SP2 server, make sure that you apply the Windows Server 2003 hotfix that is referenced in Microsoft Knowledge Base article 905214 [http://go.microsoft.com/fwlink/?linkid=3052&kbid=905214|Windows Server 2003 may stop responding when you enable Sender ID filtering on an SMTP virtual server in Exchange Server 2003 SP2]. Windows 2000 Server is in extended support mode only. Please contact your Microsoft account representative for information about obtaining the hotfix for Windows 2000 Server.
 For more information about this same issue in Windows 2000 Server, see the Microsoft Knowledge Base article 909426, [http://go.microsoft.com/fwlink/?linkid=3052&kbid=909426|Windows 2000 Server may stop responding when you enable the Sender ID Filtering setting on an SMTP virtual server in Exchange Server 2003 SP2].